6
7
Intended use
The clamping surface of the handlebar must be equal to or wider than that
of the stem.
The stem must not be modified or altered.
If spacers are mounted under the stem, the screw length must be suitable!
Check the handlebar manufacturer's specifications for specific provisions.
The statutory warranty applies to all components. If
damage occurs outside the warranty, contact us
and we try to find an individual solution.
Assembly video
Scan the code and watch
the video.
Compatibility
Guarantee / Crash Replacement
The Sixpack Millenium direct mount stem is designed for categorie 5
according to ASTM F2043.
Category 5: Extreme use (downhill, freeride, dirt)
Category 5 includes the use of bikes and their components under the
conditions of categories 1, 2, 3 and 4 as well as in demanding, heavily blocked
and extremely steep terrain, which can only be mastered by technically
experienced and very well trained riders. In this category, big jumps are
to be expected as well as intensive use in bike parks or on downhil tracks.
With these bikes it is essential to ensure that after each ride an intensive
check for possible damage is carried out. Pre-damages can lead to failure
even if further stresses are significantly lower. A regular replacement of
safety-relevant components should also be considered. Wearing appropriate
protective gear is absolutely essential. Long travel full-suspension bikes but
also dirt bikes characterize this category.
•
The tightening torque of the stem must not be exceeded.
•
Additionally, check the handlebar manufacturer's instructions for
specific provisions. In particular, the tightening torque may be
restricted by the handlebar manufacturer.
•
The assembly sequence must be observed. The clamping points
labeled "NO GAP" must be tightened first.
•
If spacers are fitted under the stem, care must be taken to ensure
the correct screw length!
•
Do not use grease or other lubricants to mount the stem.
DANGER
Danger due to incorrectly mounted stem!
