1
Regulation of trimmer string length
The brush cutter is equipped with a semi-automatic string head with a
nylon string, which allows the user to unwind the string without
stopping the engine. If the string is too short, gently touch the ground
with the cutting head while keeping the engine speed at maximum.
Each touch with the ground will cause the string to roll out by 25-35
mm. You must touch a solid surface. Do not touch the ground where
there is tall grass, as this could cause the engine to stall due to
overloading. The string will be cut using a blade that is installed in the
cover. Keep in mind that this blade is very sharp, because if it wasn’t,
an unbroken string could damage the cover. Remember that the length
of the string on the left and right should be the same. When working
with the string, be sure to install the original protective cover. If the
length on the right and left side is different, the balance of the string
head is disturbed, which causes an increase in vibration and damage to
the machine. If you feel stronger vibrations in any part of the machine,
stop the engine immediately, check and solve the problem that caused
the increase in vibration.
String head guard skirt
When using the trimmer head, make sure to attach the guard skirt.
82
EN
Summary of Contents for GRASS CUT 3.8
