42
Installing engine:
•
Fasten the engine to the tank shaft using four screws facing downwards.
•
After screwing on the engine, connect the colored connectors to the same colors.
•
Remove the engine cover, remove the reducer and connect the throttle cable to the screw (the
reducer can worn out over time when pulling out the cable).
•
Finally, put on the engine cover.
Regulation of trimmer string length:
The brush cutter is equipped with a semi-automatic string head with a nylon string, which allows the user to
unwind the string without stopping the engine. If the string is too short, gently touch the ground with the
cutting head while keeping the engine speed at maximum. Each touch with the ground will cause the string to
roll out by 25-35 mm. You must touch a solid surface. Do not touch the ground where there is tall grass, as
this could cause the engine to stall due to overloading. The string will be cut using a blade that is installed in
the cover. Keep in mind that this blade is very sharp, because if it wasn’t, an unbroken string could damage
the cover. Remember that the length of the string on the left and right should be the same. When working with
the string, be sure to install the original protective cover. If the length on the right and left side is different, the
balance of the string head is disturbed, which causes an increase in vibration and damage to the machine. If
you feel stronger vibrations in any part of the machine, stop the engine immediately, check and solve the
problem that caused the increase in vibration.
Cutting attachment guard skirt for trimmer head:
When using the trimmer head, make sure to attach the guard skirt.
