21
Side Rail Set-Up
WARNING:
It is recommended to have the side rails
upright at all times while the patient is in the bed.
However, the ultimate decision lies with the medical
personnel who are on site and can fully evaluate all factors.
WARNING:
If the side rails are not secured in the proper place, entrapment to the
patient may occur. Bed rail entrapment is a serious health risk that can result in
serious injury or even death. Sizewise recommends the care provider be mindful of
the FDA guidelines relevant to bed rail entrapment, as serious injury can result.
These guidelines can be found on the FDA website. It is the care provider’s
ultimate decision whether or not to use bed rails with the patient.
To Mount:
1. Align the side rail mount with the two pre-drilled holes (A),
located toward the center of the top deck, and place the bolts
through the holes.
2. Place the nut on the bolt underneath the deck and tighten.
3. Slide the side rail into the mount (B).
4. Place the pin and lanyard (C) below the mount to secure the
side rail.
NOTE
: Side rails for the head section are side specific. Verify the angle indicators are facing
toward the outside of the bed.
WARNING:
A fall may occur if side rail bolts are not secured properly, or not in
place, causing harm to the patient and/or care provider.