44
4. Attach the sliding saddle to the overhead beam.
Move the saddle until the bolt is secured into one of
the holes on the overhead beam.
5. Place the bolt through the sliding saddle and secure it
with a nut, as shown in the picture.
6. After securing the trapeze bar, the saddle can be repositioned into the appropriate location
without removing the nut and bolt.
Trendelenburg Disabling
To disable the Trendelenburg function
on the hand control, turn switch (A) on
the ECM, to the OFF position. This will
prevent the patient from using the
function when they should not. The
ECM is located at the head of the bed and
it is mounted to the frame.
1. Attach the end posts into the appropriate brackets on the
head and foot sections of the bed.
2. Place the overhead beam into the slots on top of each end
post.
NOTE:
Be sure to place the holes facing upward on the
overhead beam.
3. Insert the four 3/8” bolts (2 on each side) and tighten the nuts using a 9/16" wrench.
