44
P24 - Exercise with preset Watt value
In this exercise mode, you can preset WATT and other values. After you have selected this mode, the
device will prompt you to input TIME, DISTANCE, WATT, CALORIES and PULSE. Press „UP“ / „DOWN“
and „ENTER“ to input all these values. Press „START/STOP“ to start the exercise.
The Watt load depends on the rounds per minute and the level of resistance. The device is able to calcu-
late the Watt load and display the respective value. Your computer will control the tension automatically
during exercise. You can not adjust the resistance manually as usual in this programme!
Please pay attention, that if a watt preset value is of medical necessity in your case, you need definitely
talk to your doctor before using this device. Your doctor should accompany this exercise and should give
you advice on the use and surveillance.
Important hints:
• If the computer display does not show any values, please check all plug-in connections carefully to ensure that they have proper contact,
and look to see whether the batteries have been inserted correctly!
• The calorie consumption values registered and displayed with this computer merely serve as indicative values for a person of medium
stature with medium resistance setting, and can deviate considerably from the actual medically precise calorie consumption.
• The pulse values registered and displayed with this computer are merely indicative in nature and can deviate considerably from the actual
pulse.
• This computer has been tested according to the corresponding EMC standards. Even so, it is still possible for interference, in particular
electrostatic discharge, to affect the display, possibly resulting in an unwanted reset or defect display. In this case, simply restart the com-
puter (wait for it to switch off and on again) or take the batteries out briefly).
Error code: E1
This code indicates a damaged connection between computer and gear motor. Disconnect the device
from the mains supply and check all cable connections properly.
Error code: E2
This code indicates a problem with the internal memory. Disconnect the device from the mains supply
and restart.
Error code: E3
This code indicates a problem with the motor. If the error code appears again after restarting the device,
the motor may be defective.
Error codes
In special cases it may happen, that the computer shows one of the below error codes. These codes
can help to find the cause of the problem. If you cannot solve the problem on your own, please contact
the customer service right away. Never disassemble the device, as this may invalidate the warranty.
COMPUTER | USE
Summary of Contents for ISIS 23
Page 1: ...Art SF 1630 AUFBAU und BEDIENUNGSANLEITUNG SET UP and INSTRUCTION MANUAL DE GB...
Page 23: ...23 PULSMESSTABELLE...
Page 47: ...47 PULSE CHART...
Page 52: ...M V1 0 04 2014...
