Idler Sound Monitor Module
Hardware Setup
Connecting Headphones and Adjusting Headphone Volume
Figure 11 - 10.
Attaching the Headphones.
Headphon
e use requires accessory cable CMAC 5078
(Headphone cable)
.
To connect the headphones to the Microlog:
•
Connect the Headphone cable to the
USB Host/CH R/Headphone
connector on the
Microlog
.
•
Connect the headphones’ jack plug into the socket
of the Headphone cable.
Headphone Control Using the Keypad
Figure 11 - 11.
Title Bar Showing Headphone Channel and Volume.
The data collection screen’s title bar indicates the monitored channel and the
headphone volume (
0
to
+10
, or
MUTE
).
CH:1
- enveloped acoustic, or
CH:2
- raw unfiltered sound
In the
CH:1
- enveloped acoustic setting, the operator hears the high frequency sounds
that humans cannot normally hear. To accomplish this, the signal is filtered to remove
normal audible background noise (filter range = 7
kHz
–
40 kHz), and t
hen the signal is
frequency shifted so that humans can hear the high frequency industrial sounds
associated with the early onset of mechanical faults.
Control volume and channel selection using the alphanumeric keypad as follows:
Mute
- 6 ("M") - toggle mute status for the selected channel.
Volume
- Press and hold the shift key (zero / up arrow), then press the up/down arrows
to adjust the volume from 0 to 10.
Channel
- Press and hold the shift key (zero / up arrow), then press the left/right arrows
to toggle between CH:1
-
enveloped acceleration ultrasound and CH:2
- raw unfiltered
sound.
11 - 10
SKF Microlog - GX Series
User Manual
