1. Safety information
page 6
EN
1. Safety information
These instructions must be read and
understood by all persons who are in-
volved with the installation, operation,
maintenance, and repair of the product.
These instructions must be kept close to
the equipment for future reference.
Note that these installation instructions
is an integral part of the product. It
must be handed over to the new op-
erator of the product if the product is
sold.
The described product was manufactured in accor-
dance with all generally acknowledged regulations
pertaining to technology, occupational safety, and
accident prevention. However, dangers that can
cause physical injury to persons or damage to
other material assets might still occur during the
use of the product. This product should only be
operated if it has been installed in accordance with
these instructions and is safe to operate. In par-
ticular, malfunctions that might affect the safety of
the product must be rectified immediately.
In addition to the information provided
in the installation instructions, all gener-
ally applicable regulations on accident
prevention and the environment must
be observed.
1.1 Intended use
All SKF Lubrication Systems Germany
GmbH products must only be used for
their intended purpose and in
accordance with the specifications of the
installation instructions for the product
in question.
The described product is for supplying centralized
lubrication systems with lubricant and is intended
for use in centralized lubrication systems. Any
other use of this product constitutes improper use.
Hazardous materials of any kind, especially the
materials classified as hazardous by CLP
Regulation EC 1272/2008 may only be used to fill
SKF centralized lubrication systems and
components and deliv-ered and/or distributed with
the same after consulting with and receiving
written approval from SKF.
None of the products manufactured by SKF
Lubrication Systems Germany GmbH can be used
with gases, liquefied gases, gases dissolved under
pressure, steams or fluids that will reach a steam
pressure of more than 0.5 bar above the normal
atmospheric pressure (1013 mbar) in the permis-
sible application temperature range.
Unless otherwise noted, products of SKF
Lubrication Systems Germany GmbH must not be
used in conjunction with explosive atmospheres
according to the ATEX-Directice 94/9/EC.
1.2 Authorized personnel
The products described in the installation instruc-
tions may only be installed, operated, maintained,
and repaired by qualified experts. Qualified experts
are persons who have been trained, instructed, and
familiarized with the end product into which the
described product is installed. These persons are
considered capable of such tasks due to their
education, training, and experience with valid
standards, conditions, accident prevention regula-
tions, and installation measures. They should be
able to carry out the required tasks and to recog-
nize - and thus avoid - any dangers that might
otherwise occur.
A definition of what constitutes a qualified person
and who are unqualified persons are stipulated in
DIN VDE 0105 and IEC 364.
Summary of Contents for OLA Series
Page 19: ...3 Design and function page 19 EN Figure 4 Hydraulic diagram of oil air lubrication system ...
Page 49: ...blank page ...
Page 50: ...blank page ...
Page 51: ...blank page ...
