96
To adjust, modify ramp end position by turning calibration screws.
Calibration screw has a notch on top of its head.
1. Notch
Governor cup has 6 positions numbered 2 to 6. Note that in position 1
the number is substitued by a dot (due to its location on casting).
1. Position 1 (not numbered)
Each number modifies maximum engine RPM by about 200 RPM.
Lower numbers decrease engine RPM in steps of 200 RPM and high-
er numbers increase it in steps of 200 RPM.
A16D0FA
1
A16D0GA
1
Mmo2000-004b.book Page 96 Monday, May 10, 1999 9:13 AM
Summary of Contents for 2000 Mach 1
