Recommended Oil
550F/600/600 HO SDI
Engine Type
CAUTION: Use only injection oil
that flows at - 40°C (- 40°F). Do not
mismatch oil reservoir cap with
fuel tank cap. Oil reservoir cap is
identified OIL.
Oil is contained in the injection oil
reservoir.
Use only 2-stroke engine injection oil
sold by authorized SKI-DOO dealers.
ENGINE TYPE
OIL TYPE
550F and 600
XP-S
TM
mineral
injection oil
(2)
600 HO SDI
(1)
XP-S 2-stroke
synthetic blend
CAUTION:
(1)
XP-S 2-stroke synthet-
ic blend oil is specially formulated
and tested for the severe require-
ments of this engine. Use of any
other brand two-stroke oil may
void the limited warranty. Use on-
ly XP-S 2-stroke synthetic blend.
There is no known equivalent on
the market for the moment. If a
high quality equivalent were avail-
able, it could be used.
(2)
If XP-S mineral injection oil is not
available, API TC high-quality low ash
2-stroke injection oil may be used.
XP-S mineral injection oil is a special
blend of basic oil and additives spe-
cially selected to ensure unequalled lu-
brication, engine cleanliness and mini-
mum spark plug fouling.
CAUTION: Never use 4-stroke pe-
troleum or synthetic motor oil and
never mix these with outboard mo-
tor oil. Do not use NMMA TC-W,
TC-W2 or TC-W3 outboard 2-stroke
engine oils or ashless 2-stroke en-
gine oils. Avoid mixing different
brands of API TC oil as resulting
chemical reactions may cause se-
vere engine damage.
Always maintain a sufficient amount
of recommended oil in the injection oil
reservoir.
CAUTION: Check level and refill ev-
ery time you refuel. Do not mis-
match oil reservoir cap with fuel
tank cap. Install cap that is identi-
fied OIL.
WARNING
Do not overfill. Reinstall cap and
fully tighten.
Wipe off any oil
spills. Oil is highly flammable.
V800 Engine Type
Use SAE 0W 40 synthetic-based oil
that meets or exceeds the require-
ments for API service classification
SM, SL or SJ. Always check the API
service label certification on the oil
container, it must contain at least one
of the above standards.
NOTE:
This is the only recommended
viscosity to ensure proper cold start
and optimum engine protection at high
RPM and temperature.
ENGINE TYPE
OIL TYPE
V800
XP-S 0W 40
synthetic oil or
an equivalent
50
______________________
Summary of Contents for EXPEDITION TUV
