MAINTENANCE PROCEDURES
Just loosen locking nut enough to pull
calibration screw partially out and ad-
just to desired position. Do not com-
pletely remove the locking nut. Torque
locking nuts to 10 N•m (89 lbf•
in
).
NOTICE
Do not completely re-
move calibration screw otherwise
internal washers will fall off. Al-
ways adjust all 3 calibration screws
and make sure they are all set to the
same position.
A16D0HA
1
TYPICAL
1. Loosen just enough to permit rotating of
calibrate screw
WARNING
NEVER disassemble or modify the
drive pulley. Improper assembly
or modifications could cause the
pulley to explode violently un-
der the stress generated by the
high rotational speed. See your
Ski-Doo dealer for maintenance
or service of the drive pulley. Im-
proper servicing or maintenance
may affect performance and re-
duce belt life.
Always respect
maintenance schedules.
WARNING
NEVER operate engine:
– Without shields and belt guard
securely installed
– With hood and/or side panels
opened or removed.
NEVER attempt to make adjust-
ments to moving parts while en-
gine is running.
Track
Track Condition
WARNING
Remove tether cord cap from en-
gine cutout switch before perform-
ing any maintenance or adjust-
ment, unless otherwise specified.
Vehicle must be parked in a safe
place, away from the trail.
Remove tether cord cap from engine
cutout switch.
Lift the rear of the snowmobile and
support it with a wide-base snowmo-
bile mechanical stand equipped with
a protector back panel. With the en-
gine off, rotate the track by hand, and
inspect condition. If worn or cut, or
if track fibers are exposed, or if miss-
ing or defective inserts or guides are
noted; contact an authorized Ski-Doo
dealer.
WARNING
Do not modify track, including the
installation of traction enhancing
products. At speed it may cause
the track to tear and separate from
vehicle. Do not operate or rotate
a track if torn, damaged or exces-
sively worn (fibers showing).
Track Tension and Alignment
NOTE:
Track tension and alignment
are interrelated. Do not adjust one
without the other.
74
______________
Summary of Contents for Scandic SWT V800
