9.
Assembly & Adjustments
Before assembling the band saw, turn
off the saw, remove the safety key and
unplug the power cord from the electrical outlet.
The power cord must remain unplugged whenever
you are working on the saw.
Install the table (Figs. 1–3)
1. Loosen the locking knob
(1)
and rotate the blade
guard knob
(2)
to raise the upper blade guard
(3)
to
the highest position.
2. Remove table connector
(5)
.
3. Place the table on the table support by sliding the slot
(6)
in the table over the blade
(4)
, taking care not to
damage the blade.
4. Align the four holes on the bottom of the table over
the four holes in the table support
(7)
.
5. Place a washer and locking washer on each bolt
(8)
and secure the bolt through the table support and into
the table.
6. Tighten all four bolts to make sure the table is
fastened securely.
7. Replace table connector
(5)
.
Note:
The table must be properly adjusted before
operating the saw. See Table tilt adjustment (page 10).
FIG. 1
FIG. 2
FIG. 3
3
2
6
5
1
4
7
8
WARNING
!
SM 2610028633 01-13_SM 2610028633 01-13.qxp 1/9/13 7:24 AM Page 9
