-3-
Belt Sander Safety Rules
job better and safer at the rate for which it is
designed.
Do not use tool if switch does not turn it
“ON” or “OFF”.
Any tool that cannot be
controlled with the switch is dangerous and
must be repaired.
Disconnect the plug from the power source
before making any adjustments, changing
accessories, or storing the tool.
Such
preventive safety measures reduce the risk of
starting the tool accidentally.
Store idle tools out of reach of children and
other untrained persons.
Tools are
dangerous in the hands of untrained users.
Maintain tools with care. Keep cutting tools
sharp and clean.
Properly maintained tools,
with sharp cutting edges are less likely to bind
and are easier to control. Any alteration or
modification is a misuse and may result in a
dangerous condition.
Check for misalignment or binding of
moving parts, breakage of parts, and any
other condition that may affect the tools
operation. If damaged, have the tool
serviced before using.
Many accidents are
caused by poorly maintained tools. Develop a
periodic maintenance schedule for your tool.
Use only accessories that are
recommended by the manufacturer for
your model.
Accessories that may be suitable
for one tool, may become hazardous when
used on another tool.
Service
Tool service must be performed only by
qualified repair personnel.
Service or
maintenance performed by unqualified
personnel could result in a risk of injury. For
example: internal wires may be misplaced or
pinched, safety guard return springs may be
improperly mounted.
When servicing a tool, use only identical
replacement parts. Follow instructions in
the Maintenance section of this manual.
Use of unauthorized parts or failure to follow
Maintenance Instructions may create a risk of
electric shock or injury. Certain cleaning
agents such as gasoline, carbon tetrachloride,
ammonia, etc. may damage plastic parts.
Hold tool by insulated gripping surfaces
when performing a operation where the
cutting tool may contact hidden wiring or
its own cord.
Contact with a "live" wire will
make exposed metal parts of the tool "live"
and shock the operator.
Never leave the trigger locked “ON”.
Before plugging the tool in, check that the
trigger lock is “OFF”.
Accidental start-ups
could cause injury.
Unplug the sander before changing
accessories.
Accidental start-ups may occur
if sander is plugged in while changing an
accessory.
Keep your fingers and clothing away from
the belt.
They could get cut or wedged
between the pulley, belt and motor housing.
Properly adjust tracking of belt to avoid it
overhanging the housing.
A running belt
overhanging its housing can cause severe
lacerations.
Be aware of the location and setting of
the Switch "Lock-ON" Button.
If the switch
is locked "ON", be ready for emergency
situations to switch it "OFF", by first pulling
the trigger then immediately releasing it
without pressing the "Lock-ON" button.
Keep the cord to the side away from
pulleys.
The cord can be dragged into belt
housing and become entangled with the
pulleys.
Clamp or secure workpiece when
sanding.
Clamping the workpiece prevents it
from being ejected from under the sander
and leaves both hands to control the tool.
Clamp or secure sander if it is inverted
and bench mounted for use as a table
sander. Always use edge stop or guide
when sanding short or small workpieces.
Fingers or clothing can be dragged into
pulley and housing area.
Do not wet sand with this sander.
Liquids
entering the motor housing is an electrical
shock hazard.
If your tool is equipped with a dust bag,
empty it frequently and after completion
SM 2610929106 3-05 3/15/05 10:33 PM Page 3
