Skil 9350, Operating/Safety Instructions Manual

When batteries are not in
tool or charger, keep them

away from metal objects.

For example, to

protect terminals from shorting 

DO NOT

place batteries in a tool box or pocket with

nails, screws, keys, etc. Fire or injury may
result. 

DO NOT PUT BATTERIES INTO FIRE OR
EXPOSE TO HIGH HEAT. 

They may

explode.

!

WARNING

Battery Care

Battery/Charger

Before using battery charger, read all
instructions and cautionary markings on
(1) battery charger, (2) battery pack, and
(3) product using battery.

Use only the charger which accompanied
your product or direct replacement as
listed in the catalog or this manual.

Do not

substitute any other charger. Use only Skil
approved chargers with your product. See
Functional Description and Specifications.

Do not disassemble charger or operate the
charger if it has received a sharp blow,
been dropped or otherwise damaged in
any way. Replace damaged cord or plugs
immediately. 

Incorrect reassembly or

damage may result in electric shock or fire.  

Do not recharge battery in damp or wet
environment. Do not expose charger to
rain or snow. If battery case is cracked or
otherwise damaged, do not insert into
charger.

Battery short or fire may result. 

Charge only Skil approved rechargeable
batteries. 

See Functional Description and

Specifications. Other types of batteries may
burst causing personal injury and damage.

Charge battery pack in temperatures
above +40 degrees F (4 degrees C) and
below +105 degrees F (41 degrees C).

Store tool and battery pack in locations
where temperatures will not exceed 120
degrees F (49 degrees C).

This is important

to prevent serious damage to the battery
cells.

Battery leakage may occur under extreme
usage or temperature conditions. Avoid
contact with skin and eyes.

The battery

liquid is caustic and could cause chemical
burns to tissues. If liquid comes in contact
with skin, wash quickly with soap and water,
then with lemon juice or vinegar. If the liquid
contacts your eyes, flush them with water for
a minimum of 10 minutes and seek medical
attention.

Place charger on flat non-flammable
surfaces and away from flammable
materials when re-charging battery pack.

The charger and battery pack heat during
charging. Carpeting and other heat insulating
surfaces block proper air circulation which
may cause overheating of the charger and
battery pack.  If smoke or melting of the case
are observed unplug the charger immediately
and do not use the battery pack or charger.

Use of an attachment not recom-
mended or sold by Skil may result in a risk
of fire, electric shock or injury to persons.

-4-