23
Install drill bits (Fig . 20 & 21)
1. Place the chuck key into the side keyhole of
the chuck, meshing the gear teeth.
2. Turn the chuck key counterclockwise to open
the chuck jaws.
3. Insert a drill bit into the chuck far enough to
obtain maximum gripping of the chuck jaws.
4. Center the drill bit in the chuck jaws before
final tightening of the chuck.
5. Use the chuck key for the final tightening
to make sure the drill bit will not slip while
drilling.
WARNING
To reduce the risk of
injury, only use the
chuck key provided with this drill press or a
duplicate of it .
This chuck key is self-ejecting
and will “pop” out of the chuck when you let go.
This action is designed to help prevent
throwing of the chuck key from the chuck when
power is turned “ON”. Store the chuck key in
the key storage slot next to the feed hub when
not in use (Fig. 21). Do not use any other key
as a substitute; order a new one if damaged or
lost.
Laser switch (Fig . 22)
WARNING
To reduce the risk of
injury, make sure the
chuck key is removed from the chuck
before starting any drilling operation .
WARNING
DO NOT STARE
DIRECTLY AT THE LASER
BEAM! A hazard may exist if you
deliberately stare into the beam . Please
observe all safety rules as follows:
•
The laser shall be used and maintained
in accordance with the manufacturer’s
instructions.
•
Never aim the beam at any person or an object other than the workpiece.
•
Do not project the laser beam into the eyes of others.
•
Always ensure the laser beam is aimed at a workpiece without reflective surfaces as the
laser beam could be projected into your eyes or the eyes of others.
The laser switch is located under the power switch, on the left of the LED work light switch.
Fig . 21
Chuck key
Key storage
slot
Fig . 22
Power switch
Laser switch
LED work
light switch
Fig . 20
Gear teeth
Chuck key
Keyhole
Chuck jaws
Tighten
Open
Summary of Contents for DP9505-00
Page 95: ......
Page 96: ...06 22 ...
