13
LED Light (Fig . 5)
Your tool is equipped with an LED light, located
on the head of the tool. This provides additional
light without shadows on the surface of the
work piece for operation in lower-light areas.
To turn on the LED light:
•
The LED light will automatically turn on with a
slight squeeze on the variable-speed trigger
switch before the tool starts running.
•
The LED light could be turned on manually
by pressing either the LED light button or the
mode button.
To adjust the LED light brightness:
•
Every time the LED light button is pressed, the brightness will toggle between Low
Brightness and High Brightness:
a. At Low Brightness, the LED light will turn off approximately 10 seconds after the variable-
speed trigger switch is released without pressing the LED light button or the mode button
again;
b. At High Brightness, the LED light will turn off approximately 600 seconds after the
variable-speed trigger switch is released without pressing the LED light button or the mode
button again.
NOTICE:
The brightness setting of the LED light will not be stored in memory or reactivated
the next time the tool is turned on. The LED light will always illuminate at default, low
brightness when it is turned on again.
NOTICE:
The brightness can be adjusted only when the motor is not running. The LED light
button is disabled when the motor is running.
When the tool and/or battery pack becomes overloaded or too hot, the internal sensors will
turn the tool off. If the tool and/or battery pack are overloaded, the LED light will flash rapidly.
Rest the tool for a while or place the tool and battery pack separately under air flow to cool.
The LED light will flash more slowly to indicate that the battery is at low-battery capacity.
Recharge the battery pack.
Changing Work Modes
When the tool is set in forward rotation, the
work mode – a combination of rotation speed,
impact rate, and torque – can be changed to
allow a tightening force suitable to the work at
hand. Every time the mode button is pressed,
the mode will toggle between 4 work modes:
a. Low-Speed Mode - Indicator light above "1"
shines green.
b. Medium-Speed Mode - Indicator lights above
"1" and "2" shine green.
c. High-Speed Mode - Indicator lights above 1,
2, and 3 shine green.
Fig . 5
LED Light
Variable-Speed
Trigger Switch
LED Light Button
Mode Button
1
LOW
10
SECS
10
MINS
HIGH
2 3 CM
1
LOW
10
SECS
10
MINS
HIGH
2 3 CM
1
LOW
10
SECS
10
MINS
HIGH
2 3 CM
1
LOW
10
SECS
10
MINS
HIGH
2 3 CM
M
M
M
M
Fig . 6
Low-speed mode
Medium-speed
mode
High-speed mode
Control mode
