15
To remove the belt clip from the tool:
d. Remove the battery pack from the tool.
e. Use a Phillips head screwdriver (not included) to loosen the screw that attaches the belt clip
to the impact driver.
f. Remove the screw and the belt clip. Store them in a safe place for future use.
Bit Storage and Strap Fixing
(Fig . 8)
Your tool features an integrated bit holder on
the back of the tool base to conveniently store
a hex bit. There's also a strap fixing area next
to the bit holder to attach a wrist strap.
Installing and Removing Bits
Your tool is equipped with a one hand collet,
making bit installation and removal and fast.
Lock the variable-speed trigger switch “OFF”
by placing the direction-of-rotation selector in
the center position.
To install the bit:
Insert the bit directly as far as it will go into the
collet. Check to make sure that the bit is firmly
in place. (Fig. 9a)
To remove the bit:
Pull the locking sleeve forward (away from
the tool), pull the bit from the collet, and then
release the sleeve. (Fig. 9b)
Fig . 9a
Fig . 8
Bit Storage Area
Strap Fixing Area
Locking Sleeve
Fig . 9b
