9
• In case of electrical or mechanical
malfunction, immediately switch off the tool
or unplug charger from power source
EXPLANATION OF SYMBOLS ON TOOL/
CHARGER
3
Read the instruction manual beforeuse
4
Only use the charger indoors
5
Incorrect polarity of the charger connection
could cause a hazard (only charge the
battery with the charger supplied)
6
Do not dispose of electric tools and
batteries together with household waste
material
USE
• Charging battery
7
! a battery that is new or has not been
used for a longer period does not
develop its full capacity until after
approximately 5 charging/discharging
cycles
-
connect charger with both wall socket
and contact
-
indicator lights up GREEN indicating that
the battery is being charged
-
when the battery is fully charged, indicator
turns off
-
the lithium-ion battery can be charged
at any time (interrupting the charging
procedure does not damage the battery)
-
the lithium-ion battery does not have to
be empty before charging (no “memory-
effect” as with nickelcadmium batteries)
-
the tool cannot be used during the
charging procedure; it is not defective
when inoperative during the charging
procedure
-
if you anticipate long periods of nonuse
for the tool, it is best to unplug the charger
from its power source
• On/off
8
• Changing direction of rotation
9
-
when not properly set in left/right position,
switch cannot be activated
! change direction of rotation only
when tool is at a complete standstill
• Changing bits
q
-
push bit to end position in bitholder
! do not use bits with a damaged shank
• Automatic spindle-lock
Allows you to manually tighten or loosen
screws, when necessary
w
• LED-light
e
LED-light automatically lights on when
activating switch, even when selector is in
the middle (locking) position
• Bit storage
1
Offers storage for 2 bits at the front
• Battery level indicator
When indicator lights up RED while switch
is depressed half way, then the battery has
less than 30% of its capacity and should be
charged
• Two handle positions
r
• Battery protection
Switches off the tool automatically when the
battery temperature gets too high (> +65°C)
the lithium-ion battery is nearly empty (to
protect against deep discharge)
APPLICATION ADVICE
• Use the appropriate bits
t
! do not use damaged bits
! only use bits with hexagon shaft
• When turning in a screw at/near the cross
cut end or an edge of wood, predrill a hole
in order to avoid cracking of the wood
• For an optimal use of the tool a steady
pressure on the screw is required,
especially while removing
• When screwdriving in hard wood one should
pre-drill a hole
MAINTENANCE
• This tool is not intended for professional use
• Keep tool and charger clean
! unplug charger from power source
before cleaning
ENVIRONMENT
• Do not dispose of electric tools,
accessories and packaging together
with household waste material (only for
EU countries)
-
in observance of European Directive
2012/19/EC on waste of electric
and electronic equipment and its
implementation in accordance with
national law, electric tools that have
reached the end of their life must be
collected separately and returned to an
environmentally compatible recycling
facility
