SkinFab operation and settings
1. To switch the SkinFab beauty device on, press and hold the centre silver button for 2-3
seconds, the display will then light up. Choose your age by pressing the same button once
again (25.35.45.60, which means ages 20-25, 25-35, 35-45, and 45-60.)
2. Select the intensity (Low, Medium, High), by pressing the top arrow to increase and
bottom arrow to decrease.
3. Press the right arrow button to start the first phase of treatment “Cleaning”, and press it
again to go to the next phase. Press two times for phase “Massage”, press three times for
phase “Nutrient”, press four times for phase “Lifting”.
4. Press the left arrow button to come back to the previous phases.
5. Press and hold the centre silver button for a few seconds to switch the SkinFab beauty
device off.
Notice:
*Always contnect your fingers to the manual ion pad sensors on both sides of the device to
ensure the ion emission.
*There is no vibration during lifting phase.
*The device is designed with four minutes for every phase and then will stop automatically.
*The device will automatically power off if it has not been operated for 10 minutes.
1. Your new SkinFab comes with the rechargeable built in battery in a partial charged
condition.
2. Before using the SkinFab you need to put the device on the battery charger for six hours.
3. Connect the adapter to the battery charger and insert the plug of the adapter into a
socket, then place the device on the charger.
4. A red indication light will first be displayed when placing device on charge then the LCD
display will show battery life charging progress. Red light is only shown if battery is low.
5. Battery must be charged for 6 hours.
6. When the battery is fully charged, disconnect the adapter from the battery charger.
Professional at home spa treatments for beautiful skin