5
MENU MODES
There are (4) MENU levels in the MST-02 Skip-timer.
To access the different MENU levels press PREV. and NEXT simultaneously.
PAINT MENU
shows STRIPE and CYCLE numbers and MPH (Km/H).
To adjust STRIPE, the word “
STRIPE
” must appear on the display. In the Main Menu use (
+
)
or (
-
) to raise or lower the STRIPE length.
To adjust CYCLE, the word “
CYCLE
” must appear on the display. In the Main Menu press
NEXT
to adjust CYCLE length, then use (
+
) or (
-
) to raise or lower the CYCLE length.
To turn the remote hand held push button on or off, press the PREV. button until “
HAND
BUTTON
” appears on the display. Turn the remote switch option ON by pressing the (
+
), or
OFF by pressing (
-
).
To change to METRIC units, press the PREV. button until “
METRIC
” appears on the display.
Use the (
+
) button to go to metric, or the (
-
) button to change to English units.
To adjust the SETUP items, press PREV. until “
CHANGE SETUP
” appears on the display.
Press (
+
) to go to the SETUP MENU.
SETUP MENU
To change to the SETUP Menu, from the PAINT MENU, press the PREV. button until
“
CHANGE SETUP?
” appears on the display. Press the (
+
) button to enter the SETUP MENU.
To scroll through the various items in this menu, press the
PREV.
or
NEXT
buttons to change to
the next or previous menu items.
In this MENU, the (
+
) button changes the different options to be ON, and the (
-
) button changes
the various options to OFF.
BEADS MENU
is accessed from the PAINT MENU by pressing PREV. and NEXT.
In the BEADS MENU, adjust the “
BEGIN BEADS
” turn on point by using the (
+
) and (
-
)
buttons. A negative number will allow the BEADS to turn on before the paint, while a positive
number will let the PAINT turn on before the beads.
The “
END BEADS
” turn off point is the NEXT item in the BEADS MENU. A negative END
BEADS number will hold the beads on after the paint has turned off, and a positive number will
shut off the beads before the paint.
Press the PREV. button to enter the “
TEST BEADS
” menu item. With the START switch in the
STOP position press the (
+
) button. Any gun selected as SKIP, will activate the corresponding
bead gun only while the (
+
) button is pressed.
