In the following cases, the automatic adjustment of the cone of light of the
headlights is disabled, the system automatically switches only the high beam
on/off.
▶
The driving mode
Eco
is selected
» page 171
,
Selection of the driving
mode(Driving Mode Selection)
.
▶
The driving mode
Travel mode
is selected
» page 70
,
travel mode
.
In the following case the
Dynamic Light Assist
is disabled.
▶
The system is in rain or fog mode
» page 69
,
Xenon headlight
.
WARNING
The system only serves as a support and does not relieve the driver of his
or her responsibility to check the headlights and low beam and, if necessa-
ry, to switch on the lights depending on the light conditions. The manual
operation may be required for example, in the following situations.
■
When visibility is poor, e.g. fog, heavy rain, or thick snowfall.
■
Passing poorly lit road users, e.g. cyclists or pedestrians.
■
When driving around “sharp” bends.
■
Driving through poorly-lit locations.
■
The camera viewing range is obstructed by an obstacle.
CAUTION
Do not attach any stickers or similar objects to the windscreen to avoid impair-
ing the functions of the systems.
Function
Read and observe and on page 73 first.
Operating conditions
The system works under the following conditions.
The light switch is in the position
.
The system is activated.
The system is activated
» page 73
,
Switching on and off
.
The vehicle speed is over 60 km / h or for some countries more than 40
km / h.
The headlight switches off automatically when the speed falls below 30 km/h.
The system can be activated/deactivated in the Infotainment
»
Owner´s Man-
ual Infotainment
, chapter
CAR - vehicle settings
.
Switching on and off
Fig. 60
Operating lever: Headlamp assis-
tant
Read and observe and on page 73 first.
Switching on
›
Place the lever in position
A
(spring-tensioned position)
» Fig. 60
.
The instrument cluster illuminates the warning light
of the systems switch-
ed on.
Switching off
›
If the headlight
is
switched on automatically, move the lever into position
B
(spring-tensioned position)
» Fig. 60
.
The warning light
goes out. The high beam turns off.
›
If the headlight
is not
currently switched on automatically,
move
the lever in-
to position
A
(spring-tensioned position) .
The warning light
goes out. The high beam turns on.
Information messages
Read and observe and on page 73 first.
The messages and information are indicated in the instrument cluster display.
Fault: Light Assist
LIGHT ASSIST FAULT
Seek help from a specialist garage.
Light Assist: clean the windscreen!
WINDSCREEN PLEASE CLEAN
Check for any obstacles on the windscreen in the viewing area of the camera.
73
Lights and visibility
Summary of Contents for 2015 Superb
