– Turn the clutch pedal switch at the bracket 45° in
-direction of arrow- and remove it from the support.
Install
• The tappet -A- of the clutch pedal switch must not be pulled
out.
• Grease the tappet head -arrow-.
• Assign the grease via the ⇒ Electronic Catalogue of Original
Parts .
• When installing the clutch pedal switch the clutch pedal must
always remain in the off position. During the complete assem‐
bly, the clutch pedal must only be touched with the tappet head
-arrow- of the clutch pedal switch .
The clutch pedal switch is installed from the front wall.
– Insert the clutch pedal switch into the support of the bracket
and turn it 45° in -direction of arrow-.
– Insert connector for the clutch pedal switch .
– Install the footwell vent ⇒ Heating and Air Conditioning; Rep.
gr. 80 .
1.9
Removing and installing the bracket with
the master cylinder (Fabia II 2011 ►;
Roomster 2011 ►; Rapid NH 2013 ►)
Special tools and workshop equipment required
♦ Closing tool - T10249-
1.9.1
Removing
Note
After the battery earth strap is disconnected and connected, carry
out additional operations ⇒ Electrical System; Rep. gr. 27 .
– If necessary, remove engine cover ⇒ Engine; Rep. gr. 10 .
– Remove battery ⇒ Electrical System; Rep. gr. 27 .
– Remove air filter housing ⇒ Engine; Rep. gr. 23 , or ⇒ Engine;
Rep. gr. 24 .
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
Gearbox 02T - Edition 05.2014
38
