Radio
5
Mark and select menu point
– Turn the button
until the desired menu point is highlighted with an
upper and lower line
⇒
page 4, fig. 2
.
– Press the button
to select the menu point.
Set value
– Turn the button
until the desired value is set.
– Press the button
in order to confirm the set value.
The “scroll bar”
⇒
page 4, fig. 2
shows that further menu points become visible
if the sliding regulator is moved completely to the bottom.
Square brackets mean that the function is currently not available (e. g.
[Fader]
on
vehicles without rear loudspeakers).
An entry with a
opens an additional sub-menu.
A
next to an entry shows the presently selected set-up (e.°g currently played
station).
Some functions can only be switched on or off. A filled out box behind an entry
means that the function is switched on, an “empty” box means that it is switched
off.
System Setups
Press the button
and select the function key
.
You can select between the following parameters:
•
Menu language
- Menu language for the displays and the language messages.
•
Measuring unit
- determining if the distances are displayed in miles or kilom-
eters.
•
Time setting
- manual time setting. Normally the navigation unit takes over the
time from the instrument cluster of the vehicle.
•
Factory setting
- Factory setting.
Display Settings
- Set display brightness.
- Switching off the display. Press the function key or any unit button
for switching on again.
Audio settings
– Press the button
and set the desired value using the aid of the
button .
You can select between the following parameters:
•
Balance
- Setting of the volume ratio between the left and right side;
•
Fader
* - Setting of the volume ratio between the front and the rear;
•
Treble
- Treble setting;
•
Midtone
* - Midtone setting;
•
Bass
- Bass setting;
•
Volume settings
- individual volume settings for different audio sources.
Volume settings
•
Traffic announcement
- Volume of the incoming traffic announcements;
•
Navigation volume
- Volume of the navigation announcements;
•
Phone volume
* - Volume of the mobile phone calls;
•
Switch on volume
- Volume after switching on;
•
GALA
- Speed dependent volume adaptation. The radio increases automati-
cally its volume with the increasing vehicle speed.
A
1
A
A
A
1
A
1
A
1
A
B
SETUP
SYSTEM
BRIGHTNESS
DISPLAY OFF
A
1
s28k.book Page 5 Friday, May 16, 2008 10:17 AM
