8
Operation
User Manual
SKOPE B1200-2/B1200G-2
EMS Controller Operations
Introduction
The Energy Management System (EMS) Advanced controller faceplate is
located inside the refrigeration unit compartment, with the faceplate visible
behind the front panel.
The EMS Advanced controller detects variable business hours and switches
the chiller to active mode approximately two hours prior to opening, and then
changes to stand-by mode at close of business. While in the economical
stand-by mode, the temperature inside the chiller is moderated and the
cabinet lights turn off.
Self-Learning
After initial start-up, the EMS Advanced controller goes into learning mode
for 24 hours to establish the density of shopper traffic and the business’s
opening/closing pattern. It’s always gathering data about shopping activity
and updating itself. A service agent is not required if the store hours change,
or you disconnect the power to move the chiller.
The EMS Advanced controller continuously collects data from two sources:
a motion sensor
door switches
Motion Sensor
& Door Switch
The motion sensor detects activity in front of the chiller and feeds data to the
EMS Advanced controller. The motion sensor is located on the faceplate of
the EMS Advanced controller, visible on the front panel.
The chiller is fitted with door switches, one below each door. The door
switches tell the EMS Advanced controller how often the doors are opened.
A small magnet in teh door frameactivates each switch.
CAUTION
The EMS Advanced controller must only be adjusted by an
authorised service agent.
IMPORTANT
Disconnecting the refrigeration unit from the power supply
does not reset the self-learning module. Only an authorised
service agent can adjust the program.
Motion Sensor
Door Switch
EMS Controller
Front Panel
