4
PLC075TI, PLC125TI, PLC150TI, PLC200TI
SKOPE CONSORT Convection Panel Heaters
Installation Instructions
The wall bracket supplied with the heater must be used when attaching
heater to the wall. To attach heater to the wall:
1.
Remove wall bracket from the heater, with the chains attached,
by removing the two securing screws from top of the rear panel.
2.
Fix wall bracket to wall using the four fixing screw holes provided
(see Figure 1 for dimensions).
3.
Locate heater onto both bottom lugs of the wall bracket.
4.
Hinge heater upwards, and replace retaining screws with link
plates of chain attached, and move heater to upright position.
The link plates should slide under the wall bracket retaining slot.
5.
Tighten both retaining screws (see Figure 2 below).
Figure 2: Wall bracket
Wall bracket retaining slot
Heater
Retaining
screw
Fixing
screw
Chain link plate
Chain
Wall
bracket
