17
SKOPE OD460
Maintenance
User Manual
Maintenance
To ensure the chiller continues to run efficiently and reliably, the following
maintenance should be carried out:
To clean the condenser coil
Cleaning Cabinet
Keep the interior and exterior of the cabinet
clean by regular wiping with a damp cloth.
The bottom shelf can be removed to assist
with cleaning by undoing the two side fixing
screws. Ensure the bottom shelf is refitted
before reconnecting the chiller to the power
supply.
Be careful not to
wash any liquid down into
the refrigeration system, as this could lead
to refrigeration failure.
Cleaning Condenser Coil
The condenser coil must be cleaned at least
monthly with a soft brush to remove dust
and fluff (see instructions below).
Regular Servicing
A thorough service clean must be
completed by qualified service personnel
every six months.
Time Frames
Time frames specified above are indicative
only. More regular cleaning and servicing
may be required depending on chiller
placement and operating environment.
1. Remove the front panel and isolate the chiller from the power supply (see
page 16).
2. Brush the condenser coil
with a soft brush
3. Refit the front panel and reconnect to the power supply.
WARNING
Disconnect the chiller from the power supply before cleaning
the condenser coil.
Condenser coil
