7
SKOPE OD460
Installation
User Manual
Shelves
Installing the
Shelves
The chiller is supplied with three metal shelves. The shelves are different
depths, with the top shelf being the shallowest and the bottom shelf the
deepest. The bottom shelf is fixed in position, and the two top shelves are
height and angle adjustable, and removable.
The two top shelves are each held in place by two cantilevered shelf
brackets which clip into cut-outs in the cabinet back duct. Further 6mm
interval height adjustments can be made by separating the shelf bracket into
two parts and re-slotting together using the alternative slots (see image
below).
To fit the shelves
Alternative height
adjustable slots
Position for
level shelves
Position for
angled shelves
1. Clip the cantilevered shelf
brackets into the slots in
the cabinet back duct.
Use the different positions
on the bracket to set the
shelf angled or level (see
image above).
2. Sit the corresponding metal shelf on the cantilevered brackets ensuring the
back of the shelf clips over the rear of the brackets.
3. Push the cantilevered
brackets outwards until
they clip into the edge
locating slots on the side
of the shelf.
Locating slot
Shelf
Shelf brackets
