26
Replacement Procedures
Service Manual
SKOPE TME650/1000
4
Replacement Procedures
Lighting
The chiller will be fitted with either fluorescent or LED light tubes. Before
replacing a light tube, determine whether it is fluorescent or LED and replace
with the same tube type. Fluorescent and LED tubes are not interchangable.
Refer to the table below for replacement tube specifications.
Note:
LED light tubes may be fitted with rotating end caps at each end of the
tube. Ensure both end caps are positioned at the ‘0’ setting and that the light
directs across the front of the chiller.
Sign Light
For chillers fitted with a lit sign only. The sign light is replaced by removing
the front sign panel.
To replace the sign light
IMPORTANT
Replace the light tube with the same type (fluorescent or LED).
Version
Description
Part No.
Fluorescent interior
(TME650 & 1000)
35W T5 fluorescent tube (ø16mm x 1450mm)
ELL0604
LED interior
(TME650 & 1000)
22W T8 LED tube (ø26 x 1500mm)
ELL10180
Fluorescent sign
(TME650)
14W T5 fluorescent tube (ø16 x 1500mm)
ELL0601
Fluorescent sign
(TME1000)
21W T5 fluorescent tube (ø16 x 1500mm)
ELL0602
LED sign
(TME650)
9W T8 LED tube (ø26 x 600mm)
ELL10151
LED sign
(TME1000)
12W T8 LED tube (ø26 x 900mm)
ELL10299
1. Disconnect the chiller from the power supply.
2. Start at one of the top corners of the
sign unit and pull the sign panel out
from under the sign top cover.
3. Work along the length of the sign unit, pulling the sign panel out as you go.
4. Carefully remove the sign panel from the sign unit.
5. The tube can now be accessed for replacement. Rotate the failed tube until
the pins on the end of the tube align with the slots, then slide it out.
6. Fit the new tube and rotate until it clicks into position.
Continued over page
Sign Top Cover
Corner
Notch
