Page 2 of 4
2- Connect the short modular cord from [1&2 Phone on CK-1] to [LINE 1/2 on Phone].
3- Connect the audio cord from your audio source, to the AUDIO IN jack on the back of
the CK-1 box. For DIGITAL units use the cable that comes with the player.
4- Connect a MOD cord from Telephone Wall Jack 1&2 to [1&2 Line on CK-1].
5- Locate the CK-1P2 "SENSOR BOARD", peel off the white protector papers from the
bottom of the sensor board, and carefully place it OVER the LINE 1 and LINE 2 LEDs
on the Panasonic base set as shown in Fig. #2. Make sure that the numbers on the sensor
board are aligned to the middle of the select buttons on the phone.
6- Connect the Sensor Cable to the Sensor Board.
7- Connect the POWER CUBE from the CK-1 box to 115VAC power. That's it!
Testing the System:
1- Pickup line 1 on your telephone. The No."1" LED on the CK-1P2 Sensor Board should
light up.
2- Repeat this test for line 2. If both lines light up when picked up, the CK-1 is working
properly. If either light does not light up, then
a) Make sure that the CK-1P2 and Phone is connected to power.
b) Make sure that the SENSOR BOARD is aligned properly.
Lights on CK-1 Box.
When you place a line on HOLD, the corresponding LED on the rear of the CK -1P2 box
lights up to confirm the Promotion-On-Hold condition.
Fig. 2
Fig. 3
Align to edge
of Phone Display
Connect cable
Align to center'
of phone buttons
