10
Preparation
Certain kiln models may have slightly different set-up instructions. Special set-up instructions for PK
Kilns and the KM-1 Wall Mount Controller are located in the Appendices section.
●
Save packing material until test fire is complete. The kiln comes almost completely assembled. If you need
to disassemble the kiln to make it lighter or smaller to move through doors, see Appendix 1.
Load the Lid Lifter Springs
If your kiln is equipped with a spring assisted Lid Lifter, you will need to load the springs. They
have been de-tensioned to avoid damage to the kiln during shipping. Please consult Page 12 for
instructions on tensioning the springs.
Remove and Set Up Stand
●
Remove the tape holding the lid brace and lid prop if your kiln has a lid lifter , open the lid, and secure the
lid brace in place.
●
Slightly bend the stand packing cardboard to relieve the tension against the brick wall and carefully lift the
stand out of the kiln, being careful not to damage the brick or the thermocouple.
●
Remove tthe peep plugs which are taped to the stand.
●
Install the black plastic stand feet which are located in the plastic bag with the manual.
●
Place the stand where the kiln will be located. If you have an older style EnviroVent (where the fan motor
mounts directly under the kiln), place it in the stand now.
Place Slab (Kiln Bottom)
●
Undo the latches that hold the kiln slab to the kiln. Lift the kiln off the slab and place on a clean flat
padded surface. Be careful not to set the kiln on anything (watch the power cord) that will damage the
bottom row of bricks.
●
Center the slab on the stand. Allow a minimum of eighteen inches (46 cm) of spacing from walls and other
kilns.
●
If the stand is not level or wobbles, shim legs accordingly. Do not place shims between the stand and the
slab.
Placing the Kiln
●
With a partner, pick the kiln up by the section handles and rest it on top of the kiln slab (floor).
●
On models with slabs that latch to the kiln, reattach the latches.
Place Peep Plugs
Place the white porcelain peep plugs into the peepholes of the kiln. Give them a slight twist to lock
them in. If you are not using an EnviroVent, EnviroVent 2, or any other Downdraft vent, be sure to
leave the top peep plug out when firing.
Clean
Vacuum the inside of the kiln to remove dust, brick chips, and other foreign matter from around the
elements. Be sure not to get the vacuum hose or nozzle too close to the thermocouple or touchpad.
Static electricity built up in the hose can damage the electronics. Be sure all tape and tape residue is
removed from the kiln and stand.
Set Up
