42
Appendices
Appendix 1 — Disassembling Multi-section Kilns
Always Unplug a Kiln before Disassembly
●
Remove lid (Refer to page 12 for Lid Lifter and lid removal instructions).
●
Remove the screws on the left side of the control box that secure the box
to the kiln, swing the panel to the side.
●
Disconnect the numbered feeder and thermocouple wires from the
terminal strip.
●
Lift the control box up to remove it from the hinges and set it on a clean
flat surface.
●
Unbuckle the draw-pull catches between each section.
●
Lift each section using the section handles and place on a flat clean sur-
face.
Appendix 2 — Using The Lid Lifter
Lid Brace
The lid brace has been designed with a two position setting and a stop post. The stop post is a safety
feature which prevents the lid from opening too far and damaging the kiln. The lid brace provides
additional safety and allows you to open the lid wider if needed for larger pieces.
Lid Latch
The Lid Latch serves two purposes. The first is to make sure the lid stays in the closed position while
firing. To latch the lid shut, simply close the lid and swing the latch arm
over until it pops into place. Be sure to latch the lid shut prior to every fir-
ing!
There are two additional venting positions that the lid can be placed in if
the kiln is not equipped with a downdraft vent. Lift the lid up and swing
the Lid Latch into the desired venting slot. When the kiln reaches 1000°F
(537°C), close the lid and latch it shut. Always wear fireproof protective
gloves when working with any hot kiln.
Appendices
