Sky Climber
ZEABORN GUIDELINES
18.11.2020 Version 1
MANGEMNT
- Page 7 -
1.3.11 Thoroughly inspect all equipment before use to make sure that it is maintained in a safe,
workable condition. The supervisor should assign a responsible person to do this at regular
intervals.
1.3.12 In the case of apparent difficulty in the machine, steel wire rope, platform etc., notify your nearest
authorized Sky Climber representative through Technical managers, and do not use the
equipment until it is repaired or replaced.
1.3.13 In an emergency, press the red emergency stop button. This will cut all power, stop the operation
and will allow the brake of the hoists to set. Do not turn the emergency switch until the cause
has been corrected.
1.3.14 All suspended access equipment must be handled with care. Impose loads on the platform
gently. Do not drop the hoists on the platform when handling.
1.3.15 Use only Sky Climber genuine spare parts for your Sky Climber equipment. Do not alter any Sky
Climber Hoists or accessories.
1.4 SYSTEM SUPPORT
1.4.1
Make sure the platform is suspended from a strong structure and is able to support the load
imposed by the suspended platform. Do not secure to a weak or questionable structure. When
in doubt, consult office for further guidance.
1.4.2
Make sure that Aluminum Brackets used, will support the suspended platform load with a
minimum of 3:1 safety factor. In case of doubt, consult a professional rigger/engineer.
1.4.3
Tiebacks (additional support, Wire sling or canvas sling) of sufficient SWL (Min 4 Tons) must be
used on all supporting devices. Tiebacks must be kept tight and attached to a structural member
being capable of supporting the entire suspended load as well as the support system. Note:
Professionally designed Davit systems do not usually require tiebacks.
1.4.4
Always use the correct type and size of rope clamps. Steel wire rope will slip through oversize
clamps. Undersize clamps will damage the steel wire rope.
1.4.5
The nut-type used for assembling suspension systems shall be of the self-locking type.
1.4.6
Never move a suspension support with the platform being suspended. The platform shall be
lowered onto a solid surface and the suspension wires shall be slack before the suspension
supports are to be moved.
1.5 STEEL WIRE ROPE
1.5.1
Comply with codes, regulations and industrial standards which forbid or warn against the use of
kinked, bird-caged or damaged steel wire rope. Inspect the steel wire rope for wear and damage
prior to use and during operation. Steel wire rope is susceptible to serious damage if not handled
in accordance with these and other instructions in this Manual. Exposure to concentrated acids,
caustic material, corrosion, fire, electricity, undue heat or abuse damages the steel wire rope.
When such an exposure has occurred, replace the steel wire rope immediately.
WARNING : The use of kinked, birdcaged or excessively worn or damaged steel wire rope
is unlawful. Such use may result in injury or death to yourself or others.
