6
Mount 2 motor holders on each arms.
Screws used: M3*10mm + M3 locknuts
Tip : Align the centering pins from your motor holders with
the arms holes.
-
7
Insert the arms insert on each arm.
-
8
Mount the 4 arms on your frames.
Screws used: M4*40mm cone head +Knuckel
Tip : Use only the inner hole, with knuckle on top, this is
just a blank mounting.
9
Place your flight controller and RX, route all your cables.
Tip : The center of your frame is the hole…
Use the 45 * 45 mm pattern for suitable flight
controllers.
10
Mount the canopy standoff on upper main frame.
Screws used: M4*10mm
Assembly instructions Spyder / Kits SKH00-401, SKH00-402 & SKH00-403 /
Page 3
/5
