+ AAA/LR03/R03 1.5V –
+ AAA/LR03/R03 1.5V –
– AAA/LR03/R03 1.5V +
+
–
1.5 V
AAA (LR03)
+
–
1.5 V
AAA (LR03)
+
–
1.5 V
AAA (LR03)
3
x
t
When launching the Drone, face the same direction as the Drone. Green blades and
Green LEDs should be in front.
t
Practice launching, hovering and landing before attempting to learn other moves.
t
Flying 2 to 3 feet above the ground will reduce ground turbulence and make
fl
ying
easier.
t
When
fi
rst attempting to
fl
y in different directions, start by tapping the Direction stick
until you have a feel for it. Always move controls slowly until you become comfortable
operating the Drone.
t
Once you’ve mastered
fl
ying in directions, practice Rotational controls. Spinning and
keeping Drone facing the same direction you are facing makes
fl
ying easier and more
intuitive.
t
Stay 2 to 3 feet away from walls and ceilings as Drone will be drawn towards them if
you
fl
y too close.
t
If propeller blades come in contact with another object or you crash, throttle down
immediately to prevent possible or further damage.
t
If anything prevents Drone’s blades from spinning or they become jammed,
THROTTLE
DOWN IMMEDIATELY
. Do not attempt to
fl
y until obstruction has been removed and
damage
fi
xed.
t
Should something prevent Drone’s blades from spinning, Drone may
AUTO
SHUTDOWN
. The Drone will need to be turned off, then back on, to restore
fl
ying
power.
t
If the Drone
fl
ies too far away, beyond the control range of the remote, the Drone will
AUTO-LAND
to prevent the Drone from
fl
ying away out of control.
t
Occasionally, check that the two halves of the Drone body are not separating. If they
are, simply press gently and snap them back together.
WHEN NOT IN USE:
t
Always
turn
OFF
the Remote Control and the
Drone,
when not in use or when being stored
or transported.
t
Store the
Remote Control
and Drone in a dry
area at room temperature.
t
Avoid temperatures less than 40°F/4°C and
greater than 120°F/49°C.
t
Do not leave the
Remote Control or
Drone in
a car or exposed to direct sunlight. If
exposed to temperatures greater than
120°F/49°C, the
Remote Control or
Drone
batteries can be damaged or may catch
fi
re.
AUTO SHUTDOWN:
t
If battery voltage drops to an extremely low level, Drone will
automatically shutdown. The Nano Drone will need to be recharged to
restore
fl
ying power.
t
If anything prevents Drone’s blades from spinning or they become
jammed, Drone will automatically shutdown. To restore
fl
ying power, turn
OFF the Drone and then turn it ON again.
FLYING TIPS
Loosen screw in the Remote Control battery
compartment door with Philips screw driver and
insert batteries as shown. Replace door and
tighten screw.
INSTALLING REMOTE BATTERIES
OFF
ON
OFF
3
8
SIZE: 297 x 210mm (folds to 148.5 x 210mm)
PAGE 3 / PAGE 8
2B
