1
2
CHARGING
,
INSTALLING
&
CARING FOR
LIPO BATTERY IN THE DRONE
ONE TOUCH STUNTS
FRONT BARREL ROLL
REAR BARREL ROLL
BLADE GUARDS FOR BEGINNERS
NOTE:
Once a stunt has been initiated,
DO NOT adjust Throttle or press any other
controls until the stunt has been completed.
1
2
While
fl
ying forward (or reverse), press the
STUNT BUTTON
.
BARREL ROLLS
1
2
3
RIGHT FLIP
FRONT FLIP
FLIPS
1
Bring the Drone to a mid air hover without
fl
ying in any
direction. Remove
fi
nger from the
DIRECTION STICK
2
While HOVERING, press and hold the
STUNT BUTTON.
3
While still holding the
STUNT BUTTON,
tap the
DIRECTION
STICK
in the direction you want to the drone to
fl
ip.
Blade guards are great for beginning pilots and can
be easily installed if desired. The guards however add
undesired weight and reduce
fl
ight performance.
Blade guards are optional and should NOT be used
with Advanced Flight Sensitivity setting 3.
1
Insert the posts of the blade guards into
the holes of the drone.
2
Secure the blade guards with the retaining screws.
IMPORTANT:
LiPo battery can be removed from Drone by loosening
battery compartment screw, opening door and removing
the battery. When replacing the battery, be careful not
to pinch battery connector wires when closing the door.
Also ensure that wires protrude through open slots on
the sides of the battery door as shown. Make sure there
is suf
fi
cient wire slack for easily connecting and
disconnecting plugs, but not so much slack that wires
interfere with spinning blades.
1
Disconnect the LiPo battery connectors hanging out from the
back of the drone.
2
Plug the red male connector from the LiPo battery into the black
female connector end of the USB charging cord.
3
Plug the USB end of the charging cord into a USB power
source and charge battery until full.
RED LIGHT = CHARGING
GREEN LIGHT = FULLY CHARGED
4
Once fully charged, disconnect the charing cord from
battery and power source. (Always unplug from power
source when not in use).
1
2
CHARGING PRECAUTIONS:
After use, allow LiPo battery to cool down to room temperature before charging again.
t
Charge LiPo battery in an isolated area, away from excessive heat or moisture.
t
If LiPo battery swells, unplug it immediately and permanently discontinue use.
t
Do not modify, heat, or wet the battery in any way. Only recharge with provided charger.
REMOVE THE CAMERA UNIT FROM THE DRONE BEFORE PERFORMING STUNTS. STUNT
FUNCTIONS WILL NOT WORK WITH CAMERA UNIT ATTATCHED. ALSO REMOVE BLADE
GUARDS WHEN FLYING IN ADVANCED SENSITIVITY MODE 3.
IMPORTANT
Drone should be
fl
ying at least 9 feet in the air with a minimum clearance of 9 feet
in all directions before attempting stunt functions.
STUNT FUNCTIONS SHOULD BE PERFORMED OUTSIDE ONLY.
CAUTION!
9
2
SIZE: 297 x 210mm (folds to 148.5 x 210mm)
PAGE 9 / PAGE 2
2A
