1
2. . Orient .the .RedDot .Finderscope .so .that .the .sight .tube .is .facing .towards .the .front .of .the .tube.
. . Secure .the .RedDot .Finderscope .bracket .by .tightening .the .thumb .screw .on .the .mounting .platform.
For .LightChariot
™
.model .10N-AZ:
1. . Remove .the .nuts .from .the .studs .where .the .RedDot .Finderscope .will .mount.
2. . Mount .the .RedDot .Finderscope .bracket .by .placing .the .bracket .over .the .studs .protruding .from .the .
tube .and .tightening .it .down .with .the .supplied .nuts. .Orient .the .RedDot .Finderscope .so .that .the .
sight .tube .is .facing .towards .the .front .of .the .tube.
RedDot Finderscope Operation
The .RedDot .Finderscope .is .powered .by .a .long .life .-Volt .lithium .battery .(#CR202) .located .underneath .
the .front .portion .of .the .RedDot .Finderscope. .Like .all .finderscopes, .the .RedDot .Finderscope .must .be .
properly .aligned .with .the .main .telescope .before .it .can .be .used. .This .is .a .simple .process .using .the .azimuth .
and .altitude .control .knobs .located .on .the .side .and .bottom .of .the .RedDot .Finderscope. .The .alignment .
procedure .is .best .done .at .night .since .the .LED .dot .will .be .difficult .to .see .during .the .day. .Note: .Before .
using .the .RedDot .Finderscope, .you .must .first .remove .the .protective .plastic .cover .over .the .battery. .
1. . To .turn .on .the .RedDot .Finderscope, .rotate .the .variable .brightness .control .clockwise .until .you .here .
a .“click”. .To .increase .the .brightness .level .of .the .red .dot, .continue .rotating .the .control .knob .about .
180º .until .it .stops. .
Remember to remove the plastic cover over the battery, and always turn the power off after you have
found an object. This will extend the life of both the battery and the LED.
2. . Locate .a .bright .star .or .planet .and .center .it .in .a .low .power .eyepiece .in .the .main .telescope.
. . With .both .eyes .open, .look .through .the .glass .window .at .the .alignment .star.
.
If .the .RedDot .Finderscope .is .perfectly .aligned, .you .will .see .the .red .LED .dot .overlap .the .alignment .
star. .If .the .RedDot .Finderscope .is .not .aligned, .take .notice .of .where .the .red .dot .is .relative .to .the .
bright .star.
4. . Without .moving .the .main .telescope, .turn .the .RedDot .Finderscope’s .azimuth .and .altitude .alignment .
controls .until .the .red .dot .is .directly .over .the .alignment .star. .
If . the . LED . dot . is . brighter . than . the . alignment . star, . it . may . make . it . difficult . to . see . the . star. . Turn . the .
variable .brightness .control .counterclockwise, .until .the .red .dot .is .the .same .brightness .as .the .alignment .
star. .This .will .make .it .easier .to .get .an .accurate .alignment. .The .RedDot .Finderscope .is .now .ready .to .be .
used.
FIG. 7
Sight .Tube
ON/OFF
Brightness .
Control
Dovetail
Tightening
Screws
Altitude
Adjustment .
Control
Azimuth
Adjustment
Control
RedDot Finderscope
Summary of Contents for LightChariot 102AR-AZ
