Start: When machine stop, this button will start the engine as the preset model
Program: When machine stop, this button can preset four modes as below:
Manual: Led shows HA.00, this mode can set time between 0 and 20 minutes. When you press start button, you can
adjust the speed as your needs. But time can not work.
Automatic P1: Led shows P1.01, this mode will run at a certain rhythm.
Time and speed. Cannot work.
Automatic P2: Led shows P2.03, this mode will run at a certain rhythm. Time and Speed Cannot work.
Automatic P3: Led shows P2.05, this mode will run at a certain rhythm. Time ans speed cannot work.
Power: You can make the machine standby after you turn on and press this button. Then led will show ‘’_ _ _”. While
you press again it will resume to norm.
Also when you switch on and not use it for 3 minutes, it will go into standby.
Time/Speed+: When machine stop in manual mode, time can be increased between1-20 minutes (Default time: 10
minutes).
While machine works in manual mode, speed can be raised by this button.
Time/Speed-: When machine stop in manual mode, time can be reduced between 1-20 minutes (Default time: 10
minutes).
While machine works in manual mode, speed can be down by this button.
Start: See 1
Programs
Summary of Contents for SVP02
Page 1: ...SVP02 ...
