Assembly and Operating Manual Rare Bear
5
Fig. 9
- Place the receiver in the fuselage and deploy the
receiver aerials(s).
Fig. 10 Balancing
- Place the canopy on the fuselage.
- Place the battery in the model of balancing; do not
connect it.
- Make the Centre of Gravity on both sides.
- Support the model at the marked C.G. and allow it
to hang freely. The model is correctly balanced
when it hangs level, ideally with the nose inclined
slightly down.
- Adjust the position of the flight battery if necessary.
- Mark the battery location in the fuselage, so that
you can be confident of replacing it in the same
position after removing it.
Figs. 11 and 12
- Charge the flight battery.
- Switch the transmitter on, and move the throttle
stick to the
“
motor off
”
end-point.
- Place the fully charged flight pack in the fuselage
and connect it to the speed controller. Wait until
you hear the controller emit a series of beeps.
