MOSQUITO 3D PRO - INSTRUCTION MANUAL
page -13-
MOSQUITO 3D PRO --- MOSQUITO
3D PRO --- MOSQUITO 3D PRO
MOSQUITO 3D PRO --- MOSQUI
TO 3D PRO --- MOSQUITO 3D PRO
5. Connection and diagnostics for the electronic components
This diagram represents the overall connections for wiring the MOSQUITO correctly (if using Futaba or Hitec). This dia-
gram includes the separate connections pictured in the follwing page.
Testing and preparation of radio equipmen
t
Please don´t skip this section!!
Before modifying or installing any radio gear, plase take a few mi-
nutes to test everything as shown. Time spent becoming familiar
with the equipment and testing all the components can prevent dif-
ficulty.
1. Intall the crystals into the transmitter and receiver. Be certain
that the channel frequency matches.
2. Note that all electroincs plug into the receiver with the wires as
pictured (orange wire faces receiver label). Follow the diagram for
each electronic connection. Once the electronics system is con-
nected and the transmitter is turned on, follwo this step-by-step
process to check your equipment.
STEP by STEP component test:
1. Turn on the transmitter test if the transmitter is functioning nor-
mally. Make sure you fixed the helicopter so it won’t be able to take
off in any case of malfunction. Mind your hands when you connect
the battery!
2.Plug the battery into your speed controller. Wait for the speed
controller and gyro to initialize before moving the helicopter.
3. Move the aileron, elevator pitch and rudder channels to make
sure the servos work. With the gyro connected properly the rudder
servo should move when turning the helicopter.
