MOSQUITO 3D PRO - INSTRUCTION MANUAL
page -3-
MOSQUITO 3D PRO --- MOSQUITO
3D PRO --- MOSQUITO 3D PRO
MOSQUITO 3D PRO --- MOSQUI
TO 3D PRO --- MOSQUITO 3D PRO
1. Introduction
Congratulations on the purchase of SKYARTEC´s Helicopter MOSQUITO 3D PRO. The MOSQUITO 3D PRO is ideal for
beginners, intermediate and expert pilots looking for a small size full 3D capable helicopter. The MOSQUITO requires a
6 channel computer radio that supports 120 degree CCPM operation. Please check with your favorite retailer or ma-
nufactuere ro verify compatibility of your radio system of choice.
2. General information
WARNING!
This radio controlled model is not a toy! It is a precision machine requiring proper assembly an dsetup to avoid acci-
dents. It is the responsibility of the owner to operate this product in a safe manner as it can inflict serious injury. The
helicopter is unassembled and require following the assembly steps as shown in this manual tu ensure a proper flight.
As the manufacturer, we assume no liability for the use of this product.
Rules of R/C
-Always turn your transmitter on before powering the model.
-Always turn off the model by disconnecting the helicopter battery prior to turning off the transmitter.
-Always start the helicopter with throttle in the low position.
-Always perform a pre-flight inspection for safe operation.
Attention!
If you purchased your MOSQUITO without SKYARTEC 4100KV motor and are going to mount any other brushless mo-
tor, DO NOT ALLOW MAIN BLADES TO EXCEED 3000RPM. Neither rotorhead mechanics nor rotorblads will withstand
rotary forces above 3000RPM.
3. Required items
Items needed to fly the MOSQUITO
1x Radio 6 channel
1x Receiver 6 channel
4x Micro servos
1x Micro gyro
1x Brushless motor 4100RPM/Volt
1x Brushless speed controller 25A+ with BEC
1x Battery 11.1 V LI-ION or LIPO
1x Battery charger LI-ION or LIPO
Items needed to assemble the MOSQUITO
1x Set of screwdrivers
1x Screw locking glue (e.g. Threadlock)
1x hobby cutting knife
Before assembling your MSOQUITO, please mind that the parts are prepacked into several bags. These bags are num-
bered and are to be opened as displayed in section 4 in order to ease the assembly steps. Some of the spareparts,
such as aluminium parts or main rotor blades are not inside those bags but single packed.