MOSQUITO 3D PRO - INSTRUCTION MANUAL
page -4-
MOSQUITO 3D PRO --- MOSQUITO
3D PRO --- MOSQUITO 3D PRO
MOSQUITO 3D PRO --- MOSQUI
TO 3D PRO --- MOSQUITO 3D PRO
4. Assembly instruction
The set contains various labeled bags in order to simplify assembling steps. Please
open the bags step by step in order to ease the assembly. Bags are marked S-1 to S-
18 according to the assembly steps.
STEP 1 - Rotor blade holder - open BAG 1
STEP 2 - Pitch compensator- open BAG 2
Rotor blade holder (1), pitch bearing
(4+5), spacer (6) and o-ring (7) have to be
assembled to the one end of the
pitch axis (8). Add the screw-lock
glue before mounting the screw as
shown. After assembling those parts to
the one end, push the axis through the ro-
tor head (2) and assebmle the other side
of the rotor holder. Use two screwdrivers
to tighten the holding screws. Finally
mount the top (3) to the rotor head.
Take the preassembled rotor head from
step 1 and mount the pitch connectors
(9) to the rotor blade holder (1). Then con-
nect the translation lever (11) with the
mounted pitch connectors (9). Make sure
to mount them onto the ball link at the
middle of the lever. Afterwards mount the
balance piece (13) into the rotorhead (2)
and screw the seesaw holder (12) to the
rotorhead. Afterwards mount the transla-
tion levers (11) with the screws to the
seesaw holder (12). Shove the rotating
frame (10) over the seesaw holder (12).