MOSQUITO 3D PRO - INSTRUCTION MANUAL
page -6-
MOSQUITO 3D PRO --- MOSQUITO
3D PRO --- MOSQUITO 3D PRO
MOSQUITO 3D PRO --- MOSQUI
TO 3D PRO --- MOSQUITO 3D PRO
STEP 6 - Lower body
STEP 7 - Tail rotor - open BAG 6
STEP 8 - Tail rotor frame - open BAG 7
Mount the preassembled landing gear
from step 4 onto the preassembled lower
main frame from step 5. Mount the four
holding screws as shown in the picture.
Center the landing bars (16) between the
two landing gears (18). Fix the previously
set in landig-bar holding screws.
Mount both tail pitch levers (25) to both
tail rotor holders (26) as shown. Mount
one tail rotor holder and bearing
(27) to the tail rotor centerpiece
(24) by using the screw-lock glue.
Afterwards mount the other side the
same way, also using the screw-lock glue.
Finally mount the tail rotor blades (28) as
shown to the rotor holders (26). Set in the
tail axis holding screw into the center pie-
ce (24), but do not thighten it now.
Mount bearing (30A) into tail frame 1
(29) and the other bearing (30B) into tail
frame 2 (34). Set tail axis (33+32) and
the tail belt guide roller (31) and the roller
bearing (37) into tail frame 1 (29). Pull
the belt (36) with a cord or a wire through
the tail boom (48). Set the prepared tail
boom into the prepared tail frame 1 (29).
Take care that before mounting tail frame
2 (34) that the belt is in the correct posi-
tion. Put both tail frame parts together
and mount the three screws . Afterwards
mount the tail fin (35) with two screws.
Make sure that while thighten them the
tail boom is in its correct position.