MOSQUITO 3D PRO - INSTRUCTION MANUAL
page -9-
MOSQUITO 3D PRO --- MOSQUITO
3D PRO --- MOSQUITO 3D PRO
MOSQUITO 3D PRO --- MOSQUI
TO 3D PRO --- MOSQUITO 3D PRO
STEP 14 - Main frame mount - open BAG 12
STEP 15 - Rotor head mount - open BAG 13
STEP 16 - Cyclic control connectors - open BAG 14
Mount the preassembled upper main
frame from step 11 and the tail boom
with two screws to the lower body
from step 12. Mount the motor pinion
(66) to the motor (64). Afterwards
mount the motor (64) with two
screws by using the two motor spa-
cers (65).Finally mount the retaining
ring (67) with the screw. Make sure
that the axis is fixed through the retai-
ning ring and that there is no game at
the main axis in the axial direction.
Mount the swashplate (70) to the
main axis of the preassembled body
from step 14. Put the rotorhead fixing
ring (49) and the the O-stabilizer (68)
together with the rotorhead from
step 3 onto the axis and fix the rotor-
head from step 2 with the main axis
bolt (69) and tighten the fixing ring
(49) screw.
Use the steering connectors (71) by
passing them through (69) to con-
nect the swashplate with the rotor-
head as shown.