Installation and Set Up
AC input via rear socket
1.
Attach the AC adapter to the back of the SkyGuard.
2.
Plug the SkyGuard into the AC outlet.
3.
The SkyGuard LEDs will illuminate yellow indicating the system is booting.
4.
When the LEDs flash red and green, the SkyGuard is in AP mode and ready for
set up.
5.
Open the SkyBell mobile application on your mobile device and choose ADD
NEW SKYBELL.
<-
Follow the on-screen instructions to complete the setup.
DC input via micro USB
7-
On the SkyGuard, press the button below the AC adapter and remove the
adapter to access the micro USB port.
8-
Insert a 5V 2A DC micro USB power adapter into the micro USB port.
9-
Place the SkyGuard into the pedestal.
:-
Plug the power adapter into the AC outlet.
;-
The SkyGuard LEDs will illuminate yellow indicating the system is booting.
<-
When the LEDs flash red and green, the SkyGuard is in AP mode and ready for
set up.
=-
Open the SkyBell mobile application on your mobile device and choose ADD
NEW SKYBELL.
>-
Follow the on-screen instructions to complete the setup.
To reset the SkyGuard back to its factory defaults, press and continue to hold the
front button until the LEDs flash yellow (about 10 seconds after the LEDs flash blue).
Once the LEDs flash yellow, release the button and the SkyGuard will reboot. The
button press/hold process will take at least 60 seconds.