begins rapidly flashing green, then release. The LED will flash green
as the Doorbell Camera scans the Wi-Fi networks in the area. The
Doorbell Camera should enter AP Mode after a couple of minutes
and the LED should begin alternating Red and Green.
Enter AP Mode (Broadcast Syncing Mode)
Press and HOLD the Main Button until the LED begins a GREEN
rapid strobe flash, then release the button. When the LED flashes
Green, it means the Alarm.com Wi-Fi Doorbell Camera is in the
process of entering AP Mode.
The LED will alternate Red and Green when the device has entered
AP Mode.
Power Cycle
Press and HOLD the Main Button until the LED begins a Blue rapid
strobe flash. The power cycle could take up to 2 minutes.
Note
: You can power cycle the Alarm.com T r i m I I P r o
Doorbell Camera when it is in AP Mode (see instructions above).
Press and HOLD the button until the LED flashes Blue.
