bracket
and push the front of the doorbell camera toward the wall. Tighten
the set screw located on the bottom of the camera, being careful
not
to damage it (power tools should not be used with the set screw).
The camera’s LED should begin to illuminate.
LED
COLORS,
BUTTON
FUNCTIONS
AND
GENERAL
TROUBLESHOOTING
Battery Charging
If the LED is alternating between Red and Blue (HD Edition) or
pulsing Blue(Slim Line), the doorbell camera’s battery is charging.
The duration of the presyncing charge process varies due to
differences in existing doorbell circuits but normally takes less than
30 minutes. See the Power Information and Troubleshooting
section if this state persists.
Wi-Fi Connectivity
If the LED is flashing Orange, the doorbell needs to be manually
placed into AP mode. Press and hold the Main Button until the LED
