SkyeModule Nova Datasheet
-
Preliminary
Page
|
24
Skyetek Inc
1732 Wazee St. Ste 202
Denver, CO 80202
www.skyetek.com
Main 720.328.3425 Fax:720.228.2400
The object described above conforms to the requirements of EU directives through full compliance with the
following standards:
European Standards
Standard
Amendments
ETSI EN 302 208 V3.1.1 (2016-11)
None
ETSI EN 301 489-3 V2.1.0 (2016-09)
Draft
CENELEC EN 50581:2012
None
The notified body Curtis-Straus LLC, NB1797 performed review of test reports on the object of this declaration and
issued the EU-type examination certificate #CS22357.
It is required that Module set power in dBm, less antenna cable loss in dB, plus antenna gain in dBdL, must be +33
dBmERP or less to allow the object to operate as intended, and to be covered by this EU declaration of conformity.
10
Host Interface Specifications
The SkyeModule Nova supports the following microcontroller host interfaces for easy integration into existing
systems:
USB (Overrides other interfaces when connected)
TTL Serial
SPI
I
2
C
The SkyeModule Nova and the host interface board support TTL Serial and USB communications. The host
interface board provides a USB connector and a TTL to RS-232 level converter for the TTL Serial host interface. The
Host Interface system parameter determines which host interface is used for communication with the host.
Each interface is software selectable and only one host interface is active at a time, however, USB may
always be connected and overrides the current interface. The host interface is selected based on the
power-up default value and can be changed at run time. The SkyeModule Nova operates under host control
using SkyeTek Protocol v3 sent over one of the host interfaces described in this chapter.
The following sections describe the power and host communication connections for the SkyeModule Nova. The
SkyeTek Protocol and commands are described further in section 12, Communicating with the Module.
