SkyeModule Nova Datasheet
-
Preliminary
Page
|
42
Skyetek Inc
1732 Wazee St. Ste 202
Denver, CO 80202
www.skyetek.com
Main 720.328.3425 Fax:720.228.2400
NOTE
–
Setting the regulatory mode in section XXX below, will automatically set all RF parameters including the
frequency start and stop, hop spacing, modulation depth etc. It is strongly recommended that (only) this
parameter be set to maintain compliance with applicable rules for the regulatory region selected, under normal
operation.
13.3.14
Current Frequency
Sets the current frequency with which the reader singulates a tag.
Parameter address: 0x0030
Length (bytes): 4
Default value: 0x3689CAC0 (915 MHz)
This parameter is a 4-byte hex equivalent of the frequency. Table 14-11 shows hex values for commonly
used frequencies.
Read/write
13.3.15
Start Frequency
Sets the low end of the frequency range under which the reader operates.
Parameter address: 0x0031
Length (bytes): 4
Default value: 0x35C80160 (902.3 MHz)
This parameter is written with a 4-byte hex equivalent of the frequency desired. See Table 14-11 for
commonly used frequencies and their hex values.
To enable frequency hopping, set a frequency range using the Start Frequency and Stop Frequency system
parameters. Then use the Frequency Hopping Sequence parameter to set the frequency hopping mode
(either sequential or pseudo-random). To disable frequency hopping, set the Start Frequency and Stop
Frequency parameter to the same value.
Read/write
13.3.16
Stop Frequency
Sets the high end of the frequency range under which the reader operates.
The parameter address: 0x0032
Length (bytes): 4
Default value: 0x374B9420 (927.7 MHz)
This parameter is written with a 4-byte hex equivalent of the frequency desired. See table 14-11 for
commonly used frequencies and their hex values.
To enable frequency hopping, set a frequency range using the Start Frequency and Stop Frequency system
parameters. Then use the Frequency Hopping Sequence parameter to set the frequency hopping mode
(either sequential or pseudo-random). To disable frequency hopping, set the Start Frequency and Stop
Frequency parameter to the same value.
Read/write
