SkyeReader 300 User Guide
13
Copyright 2009 SkyeTek, Inc. All Rights Reserved.
b. Click and drag the Minimum or Maximum sliders in the Frequency field
to adjust the detection range.
c. Use the up or down arrows in the Modulation Depth field to adjust the
percentage for the modulation depth in increments of 10—or—type a
number between 0 and 100 directly into the field.
d. Select a power level region from the Output Power pull-down menu.
(Possible values range from 9-24 dBm in 3 dBm increments.)
4. (Optional for C1Gen2 tags) Adjust the inventory settings to improve the read
range:
a. Use the up or down arrows in the Anticipated Tags in Field field to match
the number of tags you want to detect. This automatically adjusts the
Command Retries field to a corresponding number.)
b. Use the up or down arrows in the Command Retries field to match the
number set the number of times the reader will repeat the command before
timing out. (This automatically adjusts the Anticipated Tags in Field field
to a corresponding number.)
5. Hold multiple tags in the read field.
6. Click the Start button once. SkyeWare 4 displays the detected tags in the data
display area. When complete, SkyeWare 4 also displays a green light and the
length of time required for the inventory and anti-collision process. A tag error
flashes the red light.
7. (Optional) If you selected Inventory with Loop Flag:
a. Move additional tags into the detection field and observe the reader’s
ability to detect them. (The reader rereads any tags that you leave in the
detection area.)
b. Click on the Stop button to end the loop.
8. When you finish testing, clear the data area by clicking the Clear button at the
bottom of the screen.
