SKYJACK, Page 111
SJRT Compact Series
Engine Powered
When
EZcal
hand-held device is connected to the OCM1 control module, a two line displays shows various
menus and settings. At any time the top line of the display describes the currently selected menu and the bottom
line shows the currently selected item in that menu.
Six buttons on
EZcal
allow easy navigation through the menus:
and
change the selected item (the bottom line display)
ENTER
enters the selected new menu when available (top line display changes)
and
adjusts the selected item when available
ESC
exits the current menu back to the previous menu
TOP LEVEL MENU OPTIONS
HELP
Select this menu to see a description of current
OCM1
status
DIAGNOSTICS
Select this menu to see switch input status & logged data
ACCESS LEVEL Select this menu & enter correct code to enable adjustments and calibrations
ADJUSTMENTS Select this menu to see and adjust
OCM1
settings
NOTE: this menu provides for adjustments which might be needed for different
work activities
SETUPS
Select this menu to carry out initial set-up of the
OCM1
NOTE: this menu provides for set-ups which are needed to configure the
OCM1
for a particular vehicle
HELP MENU OPTIONS
(help message)
A message displays current
OCM1
status, indicating if everything is OK or if there is
an error code (see LED Error Codes - Table 5.3)
DIAGNOSTIC MENU OPTIONS
SYSTEM
Select this menu to see general
OCM1
system information
SWITCHES
Select this menu to see switch input status
OUTPUTS
Select this menu to see
OCM1
output status
LOG
Select this menu to see logged information
DIAGNOSTIC / SYSTEM MENU OPTIONS
OUTRIGGERS
Displays various status during the auto-level function
TILT
Displays vehicle tilt in “X” and “Y” orientations measured by integral sensor
TILTED
Displays whether vehicle is tilted (YES or NO)
BATTERY
Displays battery supply voltage (on P2-12)
DIAGNOSTIC / SWITCHES MENU OPTIONS
LR/P2-1
High when the left rear outrigger is in contact with the ground
RR/P2-2
High when the right rear outrigger is in contact with the ground
RF/P2-3
High when the right front outrigger is in contact with the ground
LF/P2-4
High when the left front outrigger is in contact with the ground
EXTEND/P2-5
High to activate the auto-level function
RETRACT/P2-6
High to activate the auto-retract function
ELEV/P2-10
High when the scissor stack is stowed (“elevated” input indicates that the vehicle is
stowed).
5.9
Outrigger Control Module Instructions
Go
to
Discount-Equipment.com
to
order
your
parts
